Size guide
Measure first.
A good fit starts with an honest measurement. Use this guide to take chest, waist, hips, inseam, sleeve, and height readings for each player, then send them with your team order. ManMon confirms the right size against the actual garment before anything is cut.
Take the numbers
Six measurements cover most team apparel. Write each one down per player.
Send them in
Attach measurements to your team order or uniform design so we can match them to the garment.
We confirm
ManMon checks the readings against the actual brand cut before production. No guesswork.
How to measure
Six readings per player
Each measurement below tells you where to place the tape and what to watch for. Take them over a light base layer with the player standing relaxed.
Chest
Wrap a soft tape measure under the arms, around the fullest part of the chest, keeping it level across the back. Relax the arms at the sides — do not puff the chest out.
Measure over a light base layer, not over a hoodie or jacket.
Waist
Find the natural waist (the narrowest point, usually just above the belly button) and measure around it. Keep the tape snug, not tight, and breathe normally.
For shorts and pants, this is the waistband reference point.
Hips
Stand with feet together and measure around the fullest part of the hips and seat, keeping the tape level.
This matters most for shorts, pants, and warm-ups.
Inseam
Measure from the inside leg, from the crotch seam down to the desired hem length. Have someone help for the most accurate read.
Shorts and pants are cut to standard lengths — note your inseam so we can confirm the right fit.
Sleeve length
With the arm slightly bent, measure from the center back of the neck, across the shoulder, and down the outside of the arm to the wrist.
Used for warm-ups, coaches polos, and full-zip pieces.
Height
Stand against a wall, barefoot, and measure from the floor to the top of the head. A book held flat on the crown gives a clean mark.
Height helps us sanity-check the overall size when chest and waist are borderline.
Measuring tips
Get a clean read
- Measure in inches or centimeters — either is fine. Write down each number rather than rounding.
- Have a second person take the measurements. Self-measuring tilts the tape and reads small.
- Wear the underlayer you would actually play in. A compression tee reads differently than a sweatshirt.
- If a measurement falls between sizes, choose the larger size for athletic cuts and the smaller for a relaxed fit.
- Youth sizes run smaller than adult sizes by cut and proportion, not just by number — do not size up an adult chart for a youth player.
Brand-specific sizing
Charts are confirmed, not assumed
Sizing varies by brand and by garment — a jersey, a warm-up, and a coaches polo from the same program can each run differently. ManMon does not publish a single fixed chart, because a wrong number on a team order means a wrong cut for a whole roster.
When you send your measurements, we match them to the actual brand sizing chart for the pieces in your order and confirm each size with you before production. Treat any size estimate before that confirmation as a starting point, not a guarantee.
Questions on sizing?
Send your measurements and the pieces you are considering — ManMon will confirm the right fit.